Framing and Roofing

Step 01

Building Series: Step 1: Framing & Roofing The walls are framed with studs and wooden supports on top of the slab. Each stud is only 16 inches apart so that the wall is strong. These supports are braced from both sides of the wall so that it stays up while it’s being built. We will remove the bracing on the outside of the house once the walls are self-supporting, which requires the installation of the sheathing.

Step 02

The sheathing is a collection of plywood sheets, which give structural integrity to the walls and keep the studs square. We attach four-foot by eight-foot sheets of plywood to the studs until the wall frames are covered, and then we are able to remove the exterior bracing. This means those exterior walls are now standing up on their own!

Step 03

We leave the interior bracing up until the ceiling joists have been installed. These joists are the essential structural component of the ceiling, like the studs are for the walls. Once the ceiling joists are nailed to the top of the wall framing, it’s time to build the roof rafters. There is a ridge board in the middle of the roof where the rafters meet, and the rafters are also attached to the top of the exterior walls. (For small, single-story homes, we sometimes use a “truss roof,” which is a pre-constructed piece that is set on top of the wall frames and includes both the ceiling joists and rafters.)

Step 04

Fourth Stage: Now we finish up framing the roof by installing the roof decking, which is plywood attached to the rafters. At this point in the construction process, the framing is essentially complete, and your house will look like a house! Then, we go inside the fully framed home to remove the rest of the bracing and finish up any detail work. Finally, the roofing company will come out and complete the roof with waterproofing and shingles. Once these steps are complete, we can install the windows and put up the siding. The siding boards are nailed to the wall studs starting from the bottom, and each board will overlap the one below it in order to cover the nails and keep them waterproofed. Any parts of the exterior walls which are not covered with siding will be covered with brick. At this point, homeowners will be able to really visualize their new home!